P1407 Infiniti Auto Trouble Code
P1407 Infiniti the main thing to check is to verify the operation of the VCT solenoid. You're looking for a sticking or stuck VCt solenoid valve caused by contamination. Refer to vehicle specific repair manual to perform component tests for the VCT unit.
The leak detection pump is part of the evaporative emissions system. This system tests the fuel system to make sure it is not leaking fuel vapors into the air. The system pulls a vacuum on the fuel system and holds it for a period of time.
P1407 Infiniti Possible Solution:
Brake Switch Out of Self-Test Range Indicates that during Key On Engine Off (KOEO) Self-Test, BPP signal was high. Or during Key On Engine Running (KOER) Self -Test, the BPP signal did not cycle high and low. Open or short in (BPP) circuit Open or short in stoplamp circuits Damaged PCM Malfunction in module(s) connected to BPP circuit (Rear Electronic Module [REM] Windstar and LS6/LS8 and Lighting Control Module (LCM) Continental and Town Car) Damaged Brake Switch Misadjusted Brake Switch Check for proper function of stoplamps. Follow correct Self-Test procedures, refer to Section 2, Quick Test.
P1407 Infiniti Description For All Models :
- Infiniti Ex35
- Infiniti Fx30
- Infiniti Fx35
- Infiniti Fx45
- Infiniti G20
- Infiniti G35
- Infiniti G37
- Infiniti I30
- Infiniti I35
- Infiniti J30
- Infiniti M35
- Infiniti M45
- Infiniti Q45
- Infiniti Qx4
- Infiniti Qx56
|
P1407 Infiniti Trouble Repair :
The scent may P1407 Infiniti signal oil or coolant leaking from their normally closed-loop systems, or it may indicate dangerous exhaust gases invading your car's interior. Car and truck exhaust contains toxic gases such, so if the inside of your car as if you were standing behind your car, get out and get it fixed. Fight the urge to take a little nap first. So sleepy. That's the carbon monoxide talking, friends. At least open a window on your way to the shop. |
Code Search
Please fill the search bar to find Auto Trouble Code meaning.